Dell PowerConnect 6248 User's Guide - Page 316
ACL Bind Configuration, Interface, Select an ACL, Assign ACL Priority, Apply Changes, Show All, Remove
View all Dell PowerConnect 6248 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 316 highlights
Assigning an ACL to an Interface 1. Open the ACL Bind Configuration page. 2. In the Interface field, specify the Unit and Port, LAG, or VLAN to configure. 3. Select the IP, IPv6, or MAC ACL in the Select an ACL field. NOTE: Whenever an ACL is assigned on a port, LAG, or VLAN, flows from that ingress interface that do not match the ACL are matched to the default rule, which is Drop unmatched packets. 4. Specify the priority in Assign ACL Priority. 5. Click Apply Changes. The ACL is attached to the specified interface(s). Removing an Interface from an ACL 1. Open the ACL Bind Configuration page. 2. Click Show All. 3. In the Interface field, specify the Unit and Port, LAG, or VLAN to view the ACL bindings for that interface. 4. Select the Remove check box for one or more ACLs to remove. 5. Click Apply Changes. The specified ACL(s) are removed from the interface. Assigning ACL Membership Using CLI Commands For information about the CLI commands that perform this function, see the following chapter in the CLI Reference Guide: • ACL Commands The following table summarizes the equivalent CLI commands you use to bind an IPv6 ACL to an interface or VLAN ID. Table 7-10. IPv6 ACL Bind Configuration Commands CLI Command ipv6 traffic-filter ip access-group Description This command either attaches a specific IPv6 Access Control List (ACL) to an interface or associates it with a VLAN ID in a given direction. Applies an IP based egress ACL on an Ethernet interface or a group of interfaces. 316 Configuring Switching Information