Dell PowerConnect 6248 User's Guide - Page 556

2. Click Add to display the Add Helper IP Address page: Figure 9-24. Add Helper IP Address 3. Select a UDP Destination port name from the menu or enter the UDP Destination Port ID. Select the Default Set to configure for the relay entry for the default set of protocols. NOTE: If the DefaultSet option is specified, the device by default forwards UDP Broadcast packets for the following services: IEN-116 Name Service (port 42), DNS (port 53), NetBIOS Name Server (port 137), NetBIOS Datagram Server (port 138), TACACS Server (Port 49), and Time Service (port 37). 4. Enter the IP address of the server to which the packets with the given UDP Destination Port will be relayed. 5. Click Apply Changes. The UDP/Helper Relay is added and the device is updated. Configuring IP Helper Global Settings Using CLI Commands For information about the CLI commands that perform this function, see the following chapter in the CLI Reference Guide: • IP Helper Commands The following table summarizes the equivalent CLI commands for this feature. Table 9-22. IP Helper Global Commands CLI Command ip helper-address (global configuration) ip helper enable show ip helper-address Description Configures the relay of certain UDP broadcast packets received on any interface. Enables relay of UDP packets. Displays the IP helper address configuration. IP Helper Interface Configuration Use the IP Helper Interface Configuration page to add, show, or delete UDP Relay and Helper IP configuration for a specific interface. To display the page, click Routing →IP Helper →Interface Configuration in the tree view. 556 Configuring Routing