Dell PowerConnect 6248 User's Guide - Page 426

To display the LLDP-MED Global Configuration page, click Switching→LLDP →LLDP-MED → LLDP-MED Global Configuration in the tree view. Figure 7-99. LLDP-MED Global Configuration The LLDP-MED Global Configuration page contains the following fields: • Fast Start Repeat Count - Specifies the number of LLDP PDUs that will be transmitted when the protocol is enabled. The range is from (1 to 10). Default value of fast repeat count is 4. • Device Class - Specifies local device's MED Classification. There are four different kinds of devices, three of them represent the actual end points (classified as Class I Generic [IP Communication Controller etc.], Class II Media [Conference Bridge etc.], Class III Communication [IP Telephone etc.]). The fourth device is Network Connectivity Device, which is typically a LAN Switch/Router, IEEE 802.1 Bridge, IEEE 802.11 Wireless Access Point, and so on. Modifying the LLDP-MED Global Configuration 1. Open the LLDP Configuration page. 2. Enter a new value for the Fast Start Repeat Count. 3. Click Apply Changes. LLDP-MED parameters are saved to the switch. Configuring LLDP-MED Global Settings with CLI Commands For information about the CLI commands that perform this function, see the following chapter in the CLI Reference Guide: • LLDP Commands The following table summarizes the equivalent CLI commands for this feature. 426 Configuring Switching Information