Dell PowerConnect 6248 User's Guide - Page 664

4. Click Create. The new link is created, and you are returned to the Virtual Link Configuration page. Configuring a Virtual Link 1. Open the OSPFv3 Virtual Link Configuration page. 2. Select the virtual link to configure. 3. Modify the remaining fields as needed. 4. Click Apply Changes. 5. The virtual link is configured for OSPFv3, and the device is updated. Configuring an OSPFv3 Virtual Link using CLI Commands For information about the CLI commands that perform this function, see the following chapter in the CLI Reference Guide: • OSPFv3 Commands The following table summarizes the equivalent CLI commands for this feature. Table 10-22. OSPFv3 Virtual Link Configuration Command CLI Command area virtual-link area virtual-link dead-interval area virtual-link hello-interval area virtual-link retransmit-interval area virtual-link transmit-delay show ipv6 ospf virtual-link Description Creates the OSPF virtual interface for the specified areaid and neighbor. Configures the dead interval for the OSPF virtual interface on the virtual interface identified by areaid and neighbor. Configures the hello interval for the OSPF virtual interface on the virtual interface identified by areaid and neighbor. Configures the retransmit interval for the OSPF virtual interface on the virtual interface identified by areaid and neighbor. Configures the transmit delay for the OSPF virtual interface on the virtual interface identified by areaid and neighbor. Displays the OSPF Virtual Interface information for a specific area and neighbor. OSPFv3 Virtual Link Summary Use the OSPFv3 Virtual Link Summary page to display virtual link data by Area ID and Neighbor Router ID. To display the page, click IPv6 →OSPFv3 →Virtual Link Summary in the tree view. 664 Configuring IPv6