Dell PowerConnect 6248 User's Guide - Page 267

- Virtual Link Interface State Change - Signifies that there has been a change in the state of an OSPF virtual interface. This trap should be generated when the interface state regresses (e.g., goes from Point- to-Point to Down) or progresses to a terminal state (i.e., Point-to-Point). The factory default is disabled. - Virtual Neighbor State Change - Signifies that there has been a change in the state of an OSPF virtual neighbor. This trap should be generated when the neighbor state regresses (e.g., goes from Attempt or Full to 1-Way or Down) or progresses to a terminal state (e.g., Full). The factory default is disabled. Configuring OSPFv2 Traps Using CLI Commands For information about the CLI command that performs this function, see the SNMP Commands chapter in the CLI Reference Guide. The following table shows the equivalent CLI command you use to configure OSPFv2 traps. Table 6-60. OSPFv2 Trap Command CLI Command snmp-server enable traps ospf Description Enables OSPF traps. OSPFv3 Trap Flags The OSPFv3 Trap Flags page is used to specify which OSPFv3 traps you want to enable or disable. When the condition identified by an active trap is encountered by the switch, a trap message is sent to any enabled SNMP Trap Receivers, and a message is written to the trap log. To access the OSPFv3 Trap Flags page, click System →Trap Manager →OSPFv3 Trap Flags in the navigation tree. Configuring System Information 267