Dell PowerConnect 6248 User's Guide - Page 657

- Attempt - This state is only valid for neighbors attached to NBMA networks. It indicates that no recent information has been received from the neighbor, but that a more concerted effort should be made to contact the neighbor. This is done by sending the neighbor Hello packets at intervals of Hello Interval. - Init - In this state, a Hello packet has recently been seen from the neighbor. However, bidirectional communication has not yet been established with the neighbor (i.e., the router itself did not appear in the neighbor's Hello packet). All neighbors in this state (or greater) are listed in the Hello packets sent from the associated interface. - 2-Way - In this state, communication between the two routers is bidirectional. This has been assured by the operation of the Hello Protocol. This is the most advanced state short of beginning adjacency establishment. The (Backup) Designated Router is selected from the set of neighbors in state 2-Way or greater. - Exchange Start - This is the first step in creating an adjacency between the two neighboring routers. The goal of this step is to decide which router is the master, and to decide upon the initial DD sequence number. Neighbor conversations in this state or greater are called adjacencies. - Exchange - In this state the router is describing its entire link state database by sending Database Description packets to the neighbor. In this state, Link State Request Packets may also be sent asking for the neighbor's more recent LSAs. All adjacencies in Exchange state or greater are used by the flooding procedure. These adjacencies are fully capable of transmitting and receiving all types of OSPF routing protocol packets. - Loading - In this state, Link State Request packets are sent to the neighbor asking for the more recent LSAs that have been discovered (but not yet received) in the Exchange state. - Full - In this state, the neighboring routers are fully adjacent. These adjacencies now appears in router-LSAs and network-LSAs. • Events - The number of times this neighbor relationship has changed state, or an error has occurred. • Retransmission Queue Length - The current length of the retransmission queue. Displaying OSPFv3 Neighbors 1. Open the OSPFv3 Neighbors page. 2. Select the interface to display from the Interface drop-down menu. 3. Select the Neighbor Router ID to display. Statistics for the selected interface Neighbor ID display. Displaying OSPFv3 Neighbors Using CLI Commands For information about the CLI commands that perform this function, see the following chapter in the CLI Reference Guide: • OSPFv3 Commands The following table summarizes the equivalent CLI commands for this feature. Configuring IPv6 657