Dell PowerConnect 6248 User's Guide - Page 501

Figure 9-1. ARP Create The ARP Create page contains the following fields: • IP Address - Enter the IP address you want to add. It must be the IP address of a device on a subnet attached to one of the switch's existing routing interfaces. • MAC Address - The unicast MAC address of the device. Enter the address as six two-digit hexadecimal numbers separated by colons, for example 00:06:29:32:81:40. Adding an Entry to the ARP Table 1. Open the ARP Create page. 2. Specify the addresses to be associated. 3. Click Apply Changes. The addresses are now in the ARP cache. Adding Entries to the ARP Table Using CLI Commands For information about the CLI command that performs this function, see the following chapter in the CLI Reference Guide: • ARP Commands The following table summarizes the equivalent CLI commands for this feature. Table 9-1. ARP Create Commands CLI Command arp ip proxy-arp Description Creates an Address Resolution Protocol (ARP) entry. Enables proxy ARP on a router interface. Configuring Routing 501