Dell PowerConnect 6248 User's Guide - Page 327

Table 7-14. LAG Commands CLI Command channel-group description hashing-mode interface port-channel interface range port-channel show interfaces port-channel shutdown Description Configure a port-to-port channel. Adds a description to a LAG . Sets the hashing algorithm on trunk ports. Configure a port-channel type and enters port-channel configuration mode. Use this command in Global Configuration mode to execute a command on multiple port channels at the same time. Shows port-channel information. Disables an LAG. Storm Control A broadcast storm is the result of an excessive number of broadcast messages simultaneously transmitted across a network by a single port. Forwarded message responses can overload network resources and/or cause the network to time out. Your switch measures the incoming broadcast/multicast/unknown unicast packet rate per port and discards packets when the rate exceeds the defined value. Storm control is enabled per interface, by defining the packet type and the rate at which the packets are transmitted. Use the Storm Control page to enable and configure storm control. To display the Storm Control interface, click Switching →Ports →Storm Control in the tree view. Figure 7-27. Storm Control Configuring Switching Information 327