Dell PowerConnect 6248 User's Guide - Page 532

Configuration data for this interface display. Configuring an OSPF Interface using CLI Commands For information about the CLI commands that perform this function, see the following chapter in the CLI Reference Guide: • OSPF Commands The following table summarizes the equivalent CLI commands for this feature. Table 9-11. OSPF Interface Configuration Commands CLI Command ip ospf area ip ospf authentication ip ospf cost ip ospf dead-interval ip ospf hello-interval ip ospf network ip ospf priority ip ospf retransmit-interval ip ospf transmit-delay network area passive-interface show ip ospf interface show ip ospf interface brief Description Enables OSPFv2 and sets the area ID of an interface. Sets the OSPF Authentication Type and Key for the specified interface. Configures the cost on an OSPF interface. Sets the OSPF dead interval for the specified interface. Sets the OSPF hello interval for the specified interface. Configure OSPF to treat an interface as a point-to-point rather than broadcast interface. Sets the OSPF priority for the specified router interface. Sets the OSPF retransmit Interval for the specified interface. Sets the OSPF Transit Delay for the specified interface. Enables OSPFv2 on an interface and sets its area ID if the IP address of an interface is covered by this network command. Sets the interface or tunnel as passive. Displays the information for the IFO object or virtual interface tables. Displays brief information for the IFO object or virtual interface tables. 532 Configuring Routing