Dell PowerConnect 6248 User's Guide - Page 392

The Multicast Global Parameters page contains the following field: • Bridge Multicast Filtering - Enables or disables bridge Multicast filtering. The default value is disabled. • IGMP Snooping Status - Enables or disables IGMP snooping. The default value is disabled. • MLD Snooping Status - Enables or disables MLD snooping. The default value is disabled. Enabling Bridge Multicast Filtering on the Switch 1. Open the Multicast Global Parameters page. 2. Select Enable in the Bridge Multicast Filtering field. 3. Click Apply Changes. Bridge Multicast is enabled on the switch. Enabling Multicast Forwarding and/or IGMP Snooping Using CLI Commands For information about the CLI commands that perform this function, see the following chapter in the CLI Reference Guide: • Multicast Commands The following table summarizes the equivalent CLI commands for this feature. Table 7-38. Multicast Commands CLI Command bridge multicast filtering ip igmp snooping ipv6 mld snooping show ip mcast show ip igmp snooping interface Description Enables filtering of Multicast addresses. Enable Internet Group Management Protocol (IGMP) snooping globally or on an interface. Enables MLD Snooping globally or on an interface. Displays the system-wide multicast information. Displays IGMP snooping configuration. Bridge Multicast Group Use the Bridge Multicast Group page to create new multicast service groups or to modify ports and LAGs assigned to existing multicast service groups. Attached interfaces display in the Port and LAG tables, and reflect the manner in which each is joined to the Multicast group. To display the Bridge Multicast Group page, click Switching →Multicast Support →Bridge Multicast Group in the tree view. 392 Configuring Switching Information