Dell PowerConnect 6248 User's Guide - Page 763

Figure 12-31. Interface Membership Information The Interface Membership Information page contains the following fields: • Interface - Displays the interface on which MLD proxy is enabled. • Multicast Group IP - Select the IP multicast group address for which data is to be displayed. If no group membership reports have been received on the selected interface you will not be able to make this selection, and none of the non-configurable data will be displayed. • Last Reporter - The IP address of the source of the last membership report received for the IP Multicast group address on the MLD Proxy interface. • Uptime - The time elapsed since this entry was created. Displayed in hours:minutes:seconds. • State - The state of the host entry. A host can be in one of the following states: - Non-member. Does not belong to the group on the interface. - Delaying Member. Host belongs to the group on the interface and report timer is running. The report timer is used to send out the reports. - Idle Member. Host belongs to the group on the interface and no report timer is running. • Filter Mode - The group filter mode for the specified group on the MLD Proxy interface. Possible values are Include, Exclude, or None. • Number of Sources - The number of source hosts present in the selected multicast group. Click Refresh to refresh the data on the screen with the present state of the data in the router. Displaying IPv6 MLD Membership Information Using CLI Commands For information about the CLI command that performs this function, see the following chapter in the CLI Reference Guide: • IPv6 Routing Commands The following table summarizes the equivalent CLI commands for this feature. Configuring IP Multicast 763