Dell PowerConnect W Clearpass 100 Software 3.9 Deployment Guide - Page 347

 Scatter  Polar In general, the first field in the output series is used as the category values for the chart. The second and subsequent fields are used as the values to display on the chart. The Pie and Pie 3-D charts support only a single data point for each category value. A pie chart is used to compare the relative proportions of different values in a single data series. The Floating Column and Floating Bar charts require two data points for each category value. The data points are the high and low values for each category (in that order). The Candlestick chart requires four data points for each category value. The data points are the maximum, minimum, open and close value for each category (in that order). The Scatter chart allows plotting of one or more data series consisting of (x, y) pairs. This chart requires that the category values alternate between x and y coordinates. Table Presentations A table presentation block displays the value of an output series in a formatted table. For reports generated using the HTML output format, you may specify the table's alignment relative to the page and any styles that should be applied to the table. The table may be displayed in one of two ways. Assuming the output series dimension covers three values (A, B and C), the default table layout will displays the output series fields organized by columns: Table 30 Default Table Layouts Field 1, value A1 Field 1, value B1 Field 1, value C1 Field 2, value A2 Field 3, value A3 Field 2, value B2 Field 3, value B3 Field 2, value C2 Field 3, value C3 If you select the Transpose table check box, the columns and rows will be interchanged, which results in the following layout: Table 31 Transposed Table Layouts Field 1, value A1 Field 2, value A2 Field 3, value A3 Field 1, value B1 Field 1, value C1 Field 2, value B2 Field 2, value C2 Field 3, value B3 Field 3, value C3 Transposed tables are recommended if the output series will contain more than a few values, as in the default layout the table will end up containing more columns than rows, making it more difficult to read. Text Presentations A text presentation block may be used to insert template code into the generated report. The template for the text presentation block is evaluated when the report output is generated. See "Smarty Template Syntax" in the Reference chapter for details about the template syntax that is supported. The default reports include a standard header block for generated reports using the syntax: {include file=report_template_header.html} ClearPass Guest 3.9 | Deployment Guide Report Management | 347