Dell PowerEdge XE2420 EMC Installation and Service Manual - Page 135
BOSS riser and M.2 module, Removing the BOSS riser
View all Dell PowerEdge XE2420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 135 highlights
Figure 108. Installing the MicroSD card Next steps 1. Install the IDSDM module. 2. Follow the procedure listed in the after working inside the system. BOSS riser and M.2 module Removing the BOSS riser Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. 3. Remove the primary drive bay assembly. Steps Hold the BOSS riser by its edges, and pull the riser until the riser edge connector disengages from the expansion card connector on the system board. Installing and removing system components 135
Figure 108. Installing the MicroSD card
Next steps
1.
Install the IDSDM module
.
2.
Follow the procedure listed in the
after working inside the system.
BOSS riser and M.2 module
Removing the BOSS riser
Prerequisites
1.
Follow the safety guidelines listed in the
Safety instructions
.
2.
Follow the procedure listed in the
Before working inside your system
.
3.
Remove the primary drive bay assembly
.
Steps
Hold the BOSS riser by its edges, and pull the riser until the riser edge connector disengages from the expansion card connector
on the system board.
Installing and removing system components
135