Dell PowerEdge XE2420 EMC Installation and Service Manual - Page 84
Removing a EDSFF switch backplane
![]() |
View all Dell PowerEdge XE2420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Figure 59. Installing the drive backplane Next steps 1. Reconnect all the disconnected cables to the backplane. 2. Install all the drives. 3. Follow the procedure listed in After working inside your system. Removing a EDSFF switch backplane Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. 3. Remove all the EDSFF drives. 4. Remove all the cables that are connected to the EDSFF switch backplane. 5. Remove the EDSFF switch backplane assembly. Steps 1. Hold and pull the plunger, and slide the backplane towards rights side. 2. Lift the backplane out of the backplane tray. 84 Installing and removing system components
![](/manual_guide/products/dell-poweredge-xe2420-emc-installation-service-manual-0f96234/84.png)
Figure 59. Installing the drive backplane
Next steps
1.
Reconnect all the disconnected cables to the backplane.
2.
Install all the drives.
3.
Follow the procedure listed in
After working inside your system
.
Removing a EDSFF switch backplane
Prerequisites
1.
Follow the safety guidelines listed in the
Safety instructions.
2.
Follow the procedure listed in the
Before working inside your system.
3.
Remove all the EDSFF drives.
4.
Remove all the cables that are connected to the EDSFF switch backplane.
5.
Remove the EDSFF switch backplane assembly.
Steps
1.
Hold and pull the plunger, and slide the backplane towards rights side.
2.
Lift the backplane out of the backplane tray.
84
Installing and removing system components