Dell PowerEdge XE2420 EMC Installation and Service Manual - Page 139
Installing the M.2 SSD module, M.2 SSD module removal from BOSS card
![]() |
View all Dell PowerEdge XE2420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
Figure 113. M.2 SSD module removal from BOSS card Next steps Replace the M.2 SSD module. Installing the M.2 SSD module Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. 3. Remove the primary drive bay assembly. 4. Remove the BOSS riser. 5. Remove the BOSS card from the BOSS riser. Steps 1. Align the M.2 SSD module at an angle with the connector on the BOSS card. 2. Insert the M.2 SSD module until it is firmly seated in the BOSS card connector. 3. Using the Phillips #1 screwdriver, secure the M.2 SSD module on the BOSS card with the screw. Figure 114. M.2 SSD module installation into BOSS card Next steps 1. Install the BOSS card into the BOSS riser. 2. Install the BOSS riser. 3. Install the primary drive bay assembly. 4. Follow the procedure listed in the After working inside your system. Installing and removing system components 139
![](/manual_guide/products/dell-poweredge-xe2420-emc-installation-service-manual-0f96234/139.png)