Dell PowerEdge XE2420 EMC Installation and Service Manual - Page 66
Installing the drive into the drive carrier
![]() |
View all Dell PowerEdge XE2420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
Figure 39. Removing the drive from the drive carrier Next steps Install the drive into the drive carrier. Installing the drive into the drive carrier Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. If installed, remove the front bezel cover. 3. Remove the drive blank. NOTE: When installing a drive into the drive carrier, ensure that the screws are torqued to 4 in-lbs. Steps 1. Insert the drive into the drive carrier with the drive connector facing towards the rear of the carrier. 2. Align the screw holes on the drive with the screws holes on the drive carrier. 3. Using a Phillips #1 screwdriver, secure the drive to the drive carrier with the screws. NOTE: When installing a drive into the drive carrier, ensure that the screws are torqued to 4 in-pounds. 66 Installing and removing system components
![](/manual_guide/products/dell-poweredge-xe2420-emc-installation-service-manual-0f96234/66.png)