Dell PowerEdge XE2420 EMC Installation and Service Manual - Page 38
SATA Settings, Table 12. Processor Settings details continued, Table 13. Processor n details
View all Dell PowerEdge XE2420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Table 12. Processor Settings details (continued) Option x2APIC Mode Processor Core speed Processor Bus speed Processor n Table 13. Processor n details Option Family-Model-Stepping Brand Level 2 Cache Level 3 Cache Number of Cores Maximum Memory Capacity Microcode Description NOTE: This option is only available on certain stock keeping units (SKUs) of the processors. Enables or disables the x2APIC mode. This option is set to Enabled by default. Specifies the maximum core frequency of the processor. Displays the bus speed of the processor. NOTE: Depending on the number of CPUs, there might be up to n processors listed. The following settings are displayed for each processor installed in the system: Description Specifies the family, model, and stepping of the processor as defined by Intel. Specifies the brand name. Specifies the total L2 cache. Specifies the total L3 cache. Specifies the number of cores per processor. Specifies the maximum memory capacity per processor. Specifies the processor microcode version. SATA Settings To view the SATA Settings screen, power on the system, press F2, and click System Setup Main Menu > System BIOS > SATA Settings. Table 14. SATA Settings details Option Embedded SATA Description Enables the embedded SATA option to be set to AHCI mode , or RAID modes. This option is set to AHCI Mode by default. NOTE: 1. You might also need to change the Boot Mode setting to UEFI. Otherwise, you should set the field to Non-RAID mode. 2. No ESXi and Ubuntu OS support under RAID mode. Security Freeze Lock Write Cache Port n Sends Security Freeze Lock command to the embedded SATA drives during POST. This option is applicable only for AHCI Mode. This option is set to Enabled by default. Enables or disables the command for the embedded SATA drives during POST. This option is set to Disabled by default. Sets the drive type of the selected device. For AHCI Mode or RAID Mode, BIOS support is always enabled. 38 Pre-operating system management applications