Garmin G1000H Bell 407GX Pilot's Guide - Page 119

AUDIO PANEL AND CNS 4.3 NAV OPERATION NAV RADIO SELECTION AND ACTIVATION The NAV Frequency Box is composed of four fields; two standby fields and two active fields. The active frequencies are on the right side and the standby frequencies are on the left. A NAV radio is selected for navigation by pressing the CDI Softkey located on the PFD. The active NAV frequency selected for navigation is displayed in green. Pressing the CDI Softkey once selects NAV1 as the navigation radio. Pressing the CDI Softkey a second time selects NAV2 as the navigation radio. Pressing the CDI Softkey a third time activates GPS mode. Pressing the CDI Softkey again cycles back to NAV1. While cycling through the CDI Softkey selections, the NAV Tuning Box and the Frequency Transfer Arrow are placed in the active NAV Frequency Field and the active NAV frequency color changes to green. The three navigation modes that can be cycled through are: • VOR1 (or LOC1) - If NAV1 is selected, a green single line arrow (not shown) labeled either VOR1 or LOC1 is displayed on the HSI and the active NAV1 frequency is displayed in green. • VOR2 (or LOC2) - If NAV2 is selected, a green double line arrow (shown) labeled either VOR2 or LOC2 is displayed on the HSI and the active NAV2 frequency is displayed in green. • GPS - If GPS Mode is selected, a magenta single line arrow (not shown) appears on the HSI and neither NAV radio is selected. Both active NAV frequencies are then displayed in white. Standby Fields Active Fields Tuning Box The NAV Radio is Selected by Pressing the CDI Softkey Figure 4-17 Selecting a NAV Radio for Navigation See the Flight Instruments Section for selecting the DME (optional) and Bearing Information windows and using VOR as the source for the bearing pointer. 190-01255-00 Rev. A Garmin G1000H™ Pilot's Guide for the Bell 407GX 107