Garmin G1000H Bell 407GX Pilot's Guide - Page 378

HAZARD AVOIDANCE The Navigation Map Page Setup Menu also controls the display of traffic. The setup menu controls the map range settings. Traffic data symbols and labels can be decluttered from the display. If a map range larger than the map range setting is selected, the data is removed from the map. Maps besides the Traffic Map Page use settings based on those selected for the Navigation Map Page. Traffic information can also be displayed on the PFD Inset Map by pressing the INSET Softkey. A traffic map will appear in heading up orientation. Traffic information can also be overlaid with navigation, topographic and optional XM Weather data. Displaying traffic information (PFD Inset Map): 1) Select the INSET Softkey. 2) Select the TRAFFIC Softkey to display traffic data on the inset map (TRFC-1). 3) Select the softkey again to display the traffic-only inset (TRFC-2). 4) Select the softkey again to remove traffic data. SYSTEM STATUS The traffic mode is annunciated in the upper left corner of the Traffic Map Page. Mode Traffic System Test Initiated Traffic Mode Annunciation (Traffic Map Page) TEST (also shown in white in center of page) Traffic Display Status Icon (Other Maps) Operating OPERATING Standby STANDBY (also shown in white in center of page) Traffic System Failed* FAIL * See Table 6-20 for additional failure annunciations Table 6-19 Traffic Modes If the traffic unit fails, an annunciation as to the cause of the failure is shown in the center of the Traffic Map Page. During a failure condition, the Operating Mode cannot be selected. Traffic Map Page Annunciation NO DATA DATA FAILED FAILED Description Data is not being received from the traffic unit Data is being received from the traffic unit, but the unit is self-reporting a failure Incorrect data format received from the traffic unit Table 6-20 Traffic Failure Annunciations 366 Garmin G1000H™ Pilot's Guide for the Bell 407GX 190-01255-00 Rev. A