Garmin G1000H Bell 407GX Pilot's Guide - Page 513

APPENDIX B 13) Turn system power OFF. 14) Remove the SD card from the top card slot of the MFD. 15) Turn system power ON. 16) Press the ENT Key to acknowledge the startup screen. 17) Turn the large FMS Knob to select the AUX Page group on the MFD. 18) Turn the small FMS Knob to select the System Status Page. 19) Press the Display Database Selection Softkey to show standby navigation database information for each display (MFD1 DB, PFD1 DB). Verify the correct standby navigation database cycle information is shown for each display. NOTE: The system compares the active databases on the PFD and the MFD, and displays a system alert message 'DB Mismatch' if they are not identical. Similarly, if the standby databases on the PFD and the MFD are not identical, the system will display a 'DB Mismatch' alert for the standby navigation databases. GARMIN DATABASES The following databases are stored on Supplemental Data Cards provided by Garmin: • Expanded basemap • Obstacle • FliteCharts • Terrain • SafeTaxi • Airport Directory (AOPA) After subscribing to the desired database product, these database products will be downloaded and ultimately stored on two Supplemental Data Cards (with the exception of FliteCharts, which is loaded on only one card). Each Supplemental Data Card resides in the bottom card of each display as shown in Figure B-7. These cards must not be removed except to update the databases stored on each card. MFD PFD Figure B-7 Correct Database Locations 190-01255-00 Rev. A Garmin G1000H™ Pilot's Guide for the Bell 407GX 501