Garmin G1000H Bell 407GX Pilot's Guide - Page 510
APPENDIX B, Automatic Database Synchronization Features
View all Garmin G1000H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 510 highlights
APPENDIX B Updating the active Jeppesen navigation database (not using the Dual Navigation Database or Automatic Database Synchronization Features): 1) With the system OFF, insert the SD card containing the new navigation database version into the top card slot of the display (PFD or MFD) to be updated (label of SD card facing left). 2) Turn the system ON. A prompt similar to the following is displayed in the upper left corner of the display: Figure B-1 Standby Navigation Database Prompt 3) Press the NO Softkey to proceed to loading the active database. 4) A prompt similar to the following is displayed, press the YES Softkey to update the active navigation database. Figure B-2 Database Update Confirmation 5) After the update completes, the display starts in normal mode. Do not remove power while the display is starting. 6) Turn the system OFF and remove the SD card from the top card slot. 7) Repeat steps 1 through 6 for the other display (PFD or MFD). Remove the SD card when finished. 8) Apply power to the system and press the ENT Key to acknowledge the startup screen. 9) Turn the large FMS Knob to select the AUX Page group on the MFD. 10) Turn the small FMS Knob to select the System Status Page. 11) Press the Display Database Selection Softkey to show active navigation database information for each display (MFD1 DB, PFD1 DB). Verify the correct active navigation database cycle information is shown for each display. 498 Garmin G1000H™ Pilot's Guide for the Bell 407GX 190-01255-00 Rev. A