Garmin G1000H Bell 407GX Pilot's Guide - Page 480

ADDITIONAL FEATURES 8.8 SCHEDULER The Scheduler feature can be used to enter and display reminder messages (e.g., Phase 1 Inspection, Switch fuel tanks, or Altimeter-Transponder Check) in the Alerts Window on the PFD. Messages can be set to display based on a specific date and time (event), once the message timer reaches zero (one-time; default setting), or recurrently whenever the message timer reaches zero (periodic). Message timers set to periodic alerting automatically reset to the original timer value once the message is displayed. When power is cycled, all messages are retained until deleted, and message timer countdown is resumed. Figure 8-113 Scheduler (Utility Page) Entering a scheduler message: 1) Select the AUX - Utility Page. 2) Press the FMS Knob momentarily to activate the flashing cursor. 3) Turn the large FMS Knob to highlight the first empty scheduler message naming field. 4) Use the FMS Knob to enter the message text to be displayed in the Alertss Window and press the ENT Key. 5) Press the ENT Key again or use the large FMS Knob to move the cursor to the field next to Type. 6) Turn the small FMS Knob to select the message type:  • Event-Message issued at the specified date/time  • One-time-Message issued when the message timer reaches zero (default setting)  • Periodic-Message issued each time the message timer reaches zero 7) Press the ENT Key again or use the large FMS Knob to move the cursor to the next field. 8) For periodic and one-time message, use the FMS Knob to enter the timer value (HH:MM:SS) from which to countdown and press the ENT Key. 468 Garmin G1000H™ Pilot's Guide for the Bell 407GX 190-01255-00 Rev. A