Garmin G1000H Bell 407GX Pilot's Guide - Page 515
If the Display Database Softkey is pressed, of the Database Window B-8.
View all Garmin G1000H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 515 highlights
APPENDIX B The synchronization progress may be monitored on the AUX-System Status Page in the Sync Status section of the Database Window (Figure B-8). This section shows the synchronization status of each applicable database, including the percent complete, time remaining, and to which displays the databases are being copied. When the synchronization is complete, the status is listed as 'Complete', followed by the displays to which the databases were copied. This sub-section is only present when a sync is occurring or has occurred on the current power-up. An indication of 'Complete' still requires a power cycle before the synchronized databases will be used by the system. Figure B-8 AUX-System Status Page, Database Window The Display Database Softkey (Figure B-11) is used to place the cursor in the Database Window. Upon first press of the Display Database Softkey, the softkey will change to a selected state (black text on gray background) and the cursor will appear in the Database Window. At this point the user can scroll through all databases in the Database Window to view status information. If the Display Database Softkey is pressed repeatedly, the softkey will switch between the PFD and MFD. Database status information in the Database Window will reflect the database of the selected display. After a successful sync and restart, verify that the proper databases are now in use on the AUX-System Status Page (Figure B-8). If an error occurs during the synchronization, an error message will be displayed, followed by the affected display in the Sync Status section of the Database Window (Figure B-9). If a synchronization completes on one display, but an error occurs on another, the error message will be displayed with the affected diaplay listed after it. When an error message (Table B-1) is displayed, the problem must be corrected before the synchronization can be completed. A power cycle is required to restart synchronization when 'Card Full' or 'Err' is shown. 'Card Full' Message Figure B-9 Synchronization Error Message 190-01255-00 Rev. A Garmin G1000H™ Pilot's Guide for the Bell 407GX 503