Garmin G1000H Bell 407GX Pilot's Guide - Page 254

FLIGHT MANAGEMENT MISSED APPROACH Activating a missed approach in the active flight plan:  Press the Go Around Button. Or:  Fly past the MAP, and press the SUSP Softkey on the PFD. Or: 1) Press the PROC Key. 2) Turn the FMS Knob to highlight 'ACTIVATE MISSED APPROACH'. 3) Press the ENT Key. The aircraft automatically sequences to the MAHP. COURSE TO ALTITUDE In this missed approach procedure, the altitude immediately following the MAP (in this case '6368ft') is not part of the published procedure. It is simply a Course to Altitude (CA) leg which guides the aircraft along the runway centerline until the altitude required to safely make the first turn toward the MAHP is exceeded. This altitude is provided by Jeppesen, and may be below, equal to, or above the published minimums for this approach. In this case, if the aircraft altitude is below the specified altitude (6,368 feet) after crossing the MAP, a direct-to is established to provide a course on runway heading until an altitude of 6,368 feet is reached. After reaching 6,368 feet, a direct-to is established to the published MAHP (in this case MOGAL). If the aircraft altitude is above the specified altitude after crossing the MAP, a direct-to is established to the published fix (MOGAL) to begin the missed approach procedure. In some missed approach procedures this Course to Altitude leg may be part of the published procedure. For example, a procedure may dictate a climb to 5,500 feet, then turn left and proceed to the Missed Approach Hold Point (MAHP). In this case, the altitude would appear in the list of waypoints as '5500ft'. Again, if the aircraft altitude is lower than the prescribed altitude, a direct-to is established on a Course to Altitude leg when the missed approach procedure is activated. Course to Altitude Leg Figure 5-97 Course to Altitude 242 Garmin G1000H™ Pilot's Guide for the Bell 407GX 190-01255-00 Rev. A