HP 6125XLG R2306-HP 6125XLG Blade Switch Fundamentals Command Reference - Page 170

Field Remarks Transceiver type not supported by port hardware The port does not support this type of transceiver modules. QSFP+: RX signal loss in channel x Received signals are lost in channel x. TX fault in channel x Transmission error in channel x. TX signal loss in channel x The transmitted signal in channel x is lost. RX power high in channel x The received optical power is high in channel x. RX power low in channel x The received optical power is low in channel x. TX bias high in channel x The transmitted bias current is low. TX bias low in channel x The transmitted bias current is high. Temp high The temperature is high. Temp low The temperature is low. Voltage high The voltage is high. Voltage low The voltage is low. Transceiver info I/O error Transceiver information read/write error. Transceiver info checksum error Transceiver information checksum error. Transceiver type and port configuration mismatch The type of the transceiver module does not match the port configuration. Transceiver type not supported by port hardware The port does not support this type of transceiver modules. Examples # Display the alarms present on the transceiver module in interface Ten-GigabitEthernet 1/1/5. display transceiver alarm interface ten-gigabitethernet 1/1/5 Ten-GigabitEthernet1/1/5 transceiver current alarm information: RX loss of signal RX power low Table 25 Command output Field transceiver current alarm information RX loss of signal RX power low Description Alarms present on the transceiver module. Received signals are lost. Received power is low. display transceiver diagnosis Use display transceiver diagnosis to display the current measured values of the digital diagnosis parameters for transceiver modules. Syntax display transceiver diagnosis interface [ interface-type interface-number ] 163