HP 6125XLG R2306-HP 6125XLG Blade Switch Fundamentals Command Reference - Page 172

Parameters interface-type interface-number: Specifies an interface by its type and number. If no interface is specified, this command displays the key parameters of the transceiver modules on all interfaces of the device. Examples # Display the key parameters of the transceiver module on interface Ten-GigabitEthernet 1/1/5. display transceiver interface ten-gigabitethernet 1/1/5 Ten-GigabitEthernet1/1/5 transceiver information: Transceiver Type : STACK_SFP_PLUS Connector Type : COPPER Wavelength(nm) : N/A Transfer Distance(m) : 0.65(STACK) Digital Diagnostic Monitoring : NO Vendor Name : HP Table 27 Command output Field transceiver information Transceiver Type Connector Type Wavelength(nm) Transfer Distance(xx) Digital Diagnostic Monitoring Description Transceiver module information. Transceiver module type. Connector type options: • MPO-Multi-fiber Push On connector. • LC-1.25 mm/RJ-45 fiber connector developed by Lucent. • RJ-45. • Fiber transceiver: Central wavelength (in nm) of the transmit laser. If the transceiver supports multiple wavelengths, every two wavelength values are separated by a comma. • Copper cable: Displayed as N/A. Transfer distance, with "xx" representing the distance unit: km (kilometers) for single-mode transceiver modules and m (meters) for other transceiver modules. If the transceiver module supports multiple transfer media, the transfer distances are separated by commas. The transfer medium is included in the bracket following the transfer distance value. The following are the transfer media: • 9 um-9/125 um single-mode fiber. • 50 um-50/125 um multi-mode fiber. • 62.5 um-62.5/125 um multi-mode fiber. • TP-Twisted pair. • STACK-RF dedicated cable. Support for the digital diagnosis function: • YES-Supported. • NO-Not supported. display transceiver manuinfo Use display transceiver manuinfo to display the electronic label data for transceiver modules. 165