HP 6125XLG R2306-HP 6125XLG Blade Switch Fundamentals Command Reference - Page 171

Views Any view Predefined user roles network-admin network-operator Parameters interface [ interface-type interface-number ]: Specifies an interface by its type and number. If no interface is specified, this command displays the current measured values of the digital diagnosis parameters for the transceiver modules on all interfaces. Usage guidelines This command cannot display information for some transceiver modules. Examples # Display the current measured values of the digital diagnosis parameters for the transceiver module on interface Ten-GigabitEthernet 1/1/5. display transceiver diagnosis interface ten-gigabitethernet 1/1/5 Ten-GigabitEthernet1/1/5 transceiver diagnostic information: Current diagnostic parameters: Temp(°C) Voltage(V) Bias(mA) RX power(dBm) TX power(dBm) 36 3.31 6.13 -35.64 -5.19 Table 26 Command output Field transceiver diagnostic information Current diagnostic parameters Temp.(°C) Voltage(V) Bias(mA) RX power(dBm) TX power(dBm) Description Digital diagnosis information of the transceiver module on the interface. Current diagnosis parameters. Digital diagnosis parameter-Temperature, in °C, accurate to 1°C. Digital diagnosis parameter-Voltage, in V, accurate to 0.01 V. Digital diagnosis parameter-Bias current, in mA, accurate to 0.01 mA. Digital diagnosis parameter-RX power, in dBm, accurate to 0.01 dBm. Digital diagnosis parameter-TX power, in dBm, accurate to 0.01 dBm. display transceiver interface Use display transceiver interface to display the key parameters of transceiver modules. Syntax display transceiver interface [ interface-type interface-number ] Views Any view Predefined user roles network-admin network-operator 164