HP 6125XLG R2306-HP 6125XLG Blade Switch Fundamentals Command Reference - Page 204
ipv6 address, Default, Views, Parameters, Usage guidelines, Examples, Syntax
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 204 highlights
Default The management Ethernet interface has no IPv4 gateway configured. Views Management Ethernet interface view Parameters ip-address: Specifies an IPv4 gateway address in dotted decimal notation. Usage guidelines When the device needs to communicate with a device on a remote IPv4 network, you must specify an IPv4 gateway for the management Ethernet interface. The IPv4 gateway address must be on the same segment as the IPv4 address of the management Ethernet interface. Changing or removing the IPv4 address of the management Ethernet interface removes the port's IPv4 gateway configuration. If you execute this command multiple times, the most recent configuration takes effect. Examples # Configure the management Ethernet interface to use IPv4 gateway 192.168.1.5. system-view [boot] interface m-eth0 [boot-m-eth0] ip gateway 192.168.1.5 ipv6 address Use ipv6 address to assign an IPv6 address to the management Ethernet interface. Use undo ipv6 address to restore the default. Syntax ipv6 address ipv6-address prefix-length undo ipv6 address Default The management Ethernet interface has no IPv6 address. Views Management Ethernet interface view Parameters ipv6-address: Specifies an IPv6 address. prefix-length: Specifies a prefix length in the range of 1 to 127. Usage guidelines The management Ethernet interface can have only one IPv6 address. If you execute this command multiple times, the most recent configuration takes effect. When the management Ethernet interface is manually shut down, assigning it an IPv6 address or removing its IPv6 address activates it at the same time. 197