HP Z200 HP Z200 SFF Workstation Maintenance and Service Guide - Page 115
System fan assembly, Removing the system fan assembly
View all HP Z200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
System fan assembly This section describes how to remove and install the system fan assembly. Removing the system fan assembly To remove the system fan assembly: 1. Prepare the computer for servicing by following the Predisassembly procedures on page 68. CAUTION: Failure to follow the predisassembly procedures can result in equipment damage or data loss. 2. Remove the access panel (see Removing the access panel on page 71). 3. Remove the front bezel (see Removing the front bezel on page 72). 4. Remove the cables from the support arm on the airflow guide 5. Remove the airflow guide by pulling it straight up and out of the chassis, as shown in the following figure. (The processor heatsink is not shown.) Figure 5-41 Removing the airflow guide ENWW Removing and installing components 103