HP Z200 HP Z200 SFF Workstation Maintenance and Service Guide - Page 97
Removing a hard disk or media card from the drive cage, CAUTION
View all HP Z200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
10. Connect the power cable (1) and data cable (2) to the rear of the optical drive. Figure 5-18 Connecting the power and data cables 11. Carefully rotate the drive cage back down to its normal position. CAUTION: Be careful not to pinch any cables or wires when rotating the drive cage down. See Cable management on page 93. 12. Replace the front bezel (see Installing the front bezel on page 72). 13. Replace the access panel (see Installing the access panel on page 71). 14. Restore all connections and equipment that you removed during the Predisassembly procedures on page 68. Removing a hard disk or media card from the drive cage The 3.3 cm (3.5 in) drive is located underneath the 13.3 cm (5.25 in) optical drive. A media card can also be installed at this location. If an optical drive is present, you must remove it before removing the hard drive. To remove a hard drive or media card from the drive cage: 1. Follow the procedures listed in the Predisassembly for drives on page 77 section. CAUTION: Failure to follow the predisassembly procedures can result in equipment damage or data loss. 2. Remove the access panel (see Removing the access panel on page 71). 3. Remove the front bezel (see Removing the front bezel on page 72). 4. Remove the optical disk drive if it is present. (See Removing an optical drive on page 80.) ENWW Removing and installing components 85