HP Z200 HP Z200 SFF Workstation Maintenance and Service Guide - Page 86
Access panel sensor (optional), Removing the access panel sensor
View all HP Z200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
6. Install the security screw next to the middle front bezel release tab to secure the front bezel in place. Figure 5-6 Installing the Front Bezel Security Screw 7. Replace the access panel. 8. Reconnect all connections and equipment listed in the Predisassembly procedures on page 68. Access panel sensor (optional) The access panel sensor is a remote solenoid that detects when the access panel is opened. This section describes how to remove and install the sensor. Removing the access panel sensor To remove the access panel sensor: 1. Prepare the computer for servicing by following the Predisassembly procedures on page 68. CAUTION: Failure to follow the predisassembly procedures can result in equipment damage or data loss. 2. Remove the access panel (see Removing the access panel on page 71). 74 Chapter 5 Replacing components ENWW