HP Z200 HP Z200 SFF Workstation Maintenance and Service Guide - Page 88
Access panel solenoid lock, Removing the access panel solenoid lock, Removing and installing drives . - sff
View all HP Z200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Access panel solenoid lock The access panel solenoid lock provides a method to lock the access panel by means of a local or remote signal-controlled solenoid. This section describes how to remove and install the access panel solenoid lock. Removing the access panel solenoid lock To remove the access panel solenoid lock: 1. Prepare the computer for servicing by following the Predisassembly procedures on page 68. CAUTION: Failure to follow the predisassembly procedures can result in equipment damage or data loss. 2. Remove the access panel (see Removing the access panel on page 71). 3. Remove the screw that fastens the solenoid lock to the chassis (1) as shown in the following figure. 4. Disconnect the access panel solenoid lock cable from the system board (2). 5. Pull the solenoid lock assembly inward and then up (3) to remove the assembly from the chassis. Figure 5-8 Removing the access panel solenoid lock Installing the access panel solenoid lock Reverse the above steps to install the access panel solenoid lock. This involves connecting the solenoid lock cable to the system board and fastening the solenoid lock to the chassis. Removing and installing drives . This section describes how to remove and install the Z200 SFF drives: ● Optical disk drive ● Internal hard disk drive ● Optional hard disk drive or media card reader 76 Chapter 5 Replacing components ENWW