Netgear FS752TPS FS752TS Setup Manual - Page 100
Switching > STP > Advanced > STP Configuration, Global Settings, Spanning Tree State, Status
View all Netgear FS752TPS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
FS700TS Smart Switch Software Administration Manual To configure STP on the device: 1. Click Switching > STP > Advanced > STP Configuration. The Advanced STP Configuration screen displays: Figure 4-17 The Advanced STP Configuration screen contains the following fields: Global Settings • Spanning Tree State - Select the STP state on the device. The possible field values are: - Enable - Enable STP on the device. - Disable - Disable STP on the device. Status • Bridge Identifier - Displays the Bridge priority and MAC address. • Time Since Topology Change - Displays the amount of time that has elapsed since the bridge was initialized or reset, and the last topographic change that occurred. The time is displayed in a day-hour-minute-second format, such as 2 days 5 hours 10 minutes and 4 seconds. The current root port and current root cost display as zero when the device is not connected to the network. 4-24 v1.0, September 2007 Configuring Switching Settings