Yamaha MO6 Owner's Manual - Page 174

Performance Edit mode Part Edit Part Edit [PERFORM] ➞ Performance selection ➞ [EDIT] ➞ Part selection These parameters are for editing the individual Parts that make up a Performance. [F1] VOICE [SF1] VOICE PartSw (Part Switch) Bank Number [SF2] MODE Mono/Poly ArpSwitch (Arpeggio Switch) [SF3] LIMIT NoteLimitH (Note Limit High) NoteLimitL (Note Limit Low) VelLimitH (Velocity Limit High) VelLimitL (Velocity Limit Low) [SF4] PORTA (Portamento) Switch Time Mode [SF5] OTHER PB (Pitch Bend) Upper, PB (Pitch Bend) Lower VelSensDpt (Velocity Sensitivity Depth) You can select a voice for each part. Set each pat to on or off. Settings: on, off Determines the Voice Bank (page 40) for each Part. Determines the Voice Program number for each Part. Determines the playback method of the Voice for each Part-monophonic (single notes only) or polyphonic (multiple notes). Settings: mono, poly n This parameter is not available for the part to which the Drum Voice is assigned. Determines whether Arpeggio is on or off for the currently selected Part. Settings: on, off Determines the lowest and highest notes of the keyboard range for each Part. Each Part will only sound for notes played within its specified range. Settings: C -2 - G8 n If you specify the highest note first and the lowest note second, for example "C5 to C4," then the note range covered will be "C-2 to C4" and "C5 to G8." n You can set the note by pressing the keyboard while holding the [INFORMATION] button. Determines the minimum and maximum values of the velocity range within which each Part will respond. Each Part will only sound for notes played within its specified velocity range. Settings: 1 - 127 n If you specify the maximum value first and the minimum value second, for example "93 to 34," then the velocity range covered will be "1 to 34" and "93 to 127." Determines the Portamento parameters for each Part. Portamento is used to create a smooth transition in pitch from the first note played on the keyboard to the next. Determines whether Portamento is on or off. Settings: off, on Determines the pitch transition time. Higher values result in a longer pitch change time. Settings: 0 -127 Determines the Portamento mode. Settings: fingr (fingered), full (full time) fingr (fingered) ......... Portamento is only applied when you play legato (playing the next note before releasing the previous one). full (full time Portamento is always applied. n These Portamento parameters above are not available for the part to which the Drum voice is assigned. Determines the amount and direction of Pitch Bend range. Details are same as that in the Common Edit parameters in Normal Voice mode (page 154). Determines the degree to which the resulting volume of the tone generator responds to your playing strength. The higher the value, the more the volume changes in response to your playing strength (as shown at right). Settings: 0 - 127 When Offset (below) is set to 64: Depth = 127 Depth = 64 127 Actual resulting velocity (affecting the tone generator) Depth = 32 Depth = 0 0 127 Velocity with which you play a note Voice mode Performance mode Song mode Pattern mode Mixing Voice mode Reference Utility mode File mode Master mode 174 Owner's Manual