Kyocera KM-6030 PRESCRIBE Commands Command Reference Manual Rev 4.8 - Page 13

Overview of PRESCRIBE Commands by Function Page Control, Text, and Comment Commands The placement commands determine where text will be placed on the page. Command CMNT CTXT PAGE RTTX RTXT TEXT Function CoMmeNT print Centered TeXT start new PAGE RoTate TeXt print Right-aligned TeXT print TEXT Page 59 69 179 234 236 348 Margin and Page Portrait/Landscape Orientation Commands These commands are used to set the top, bottom, right, and left margins, and to specify portrait or landscape page orientation. Normal text data is printed inside the margins, but the TEXT and RTEXT commands can be used to print character strings or graphics anywhere in the entire printable area of the page, regardless of the margin settings. There are several commands for setting margins, so it is possible to select the one that best suits the purpose at hand. Margin settings can be changed in the middle of a page. Note that the following limitations apply to the margin setting commands. • The right margin must be at least one space character to the right of the left margin. • The bottom margin must be at least one line below the top margin. • It is not possible to specify negative values as margin settings. For example, a right margin setting beyond the printable area's right edge would be brought back just inside the right edge of the printable area. In like manner, it is not possible to use a bottom margin setting that would place the bottom margin past the bottom edge of the printable area. An easy way to set the right and bottom margins to the very edge of the printable area is to use a large value such as 100 (centimeters). The margins and page orientation can be reset by using the RES command. Command Function Page SBM Set Bottom Margin 264 SLM Set Left Margin 307 SLPP Set Lines Per Page 310 SPL Set Page Length 320 SPO Set Page Orientation 322 SPW Set Page Width 326 SRM Set Right Margin 328 STM Set Top Margin 338 Margins and page orientation are more fully explained in Section 1.3. of the Technical Reference manual. 3