Kyocera KM-6030 PRESCRIBE Commands Command Reference Manual Rev 4.8 - Page 16

PRESCRIBE Command Reference If an attempt is made to create figures outside of the printable area using these commands, the coordinates are adjusted automatically so that the figures print inside the printable area. As in the example below, this can produce printed results different from what is expected. Print settings according to command Actual printed result Printing extremely complex figures can exhaust printing system memory. Downloadable fonts can be particularly taxing on printing system memory, producing unexpected print results. It may be possible to correct the problem by removing some of the downloaded fonts or by simplifying the graphic. To determine current memory usage, refer to a status page. Command Function Page ARC draw filled-in ARC 28 BLK draw filled-in BLocK 40 BOX draw BOX 42 CIR draw CIRcle 52 DAP Draw to Absolute Position 73 DPAT select Dashed PATtern 78 DRP Draw to Relative Position 80 DRPA Draw to Relative Position specified by Angle 82 DZP Draw to Zero-relative Position 87 FPAT generate Fill PATtern 110 GPAT set Gray PATtern 122 PAT select fill PATtern 184 PIE draw PIE chart 199 SPD Set Pen Diameter 318 XPAT generate eXpanded fill PATtern 393 Path Mode Graphics Commands The following commands provide a variety of path construction operators and painting operators for stroking or filling paths. Command Function Page CLIP CLIP current path 54 CLPR CLiP Rectangular area 55 CLSP CLoSe Path 57 CPTH Character PaTH 64 6