Kyocera KM-6030 PRESCRIBE Commands Command Reference Manual Rev 4.8 - Page 297

SEM SEM - Set Emulation Mode Format SEM mode; Parameter mode: 0 = Line Printer 1 = IBM Proprinter X-24E 2 = Diablo 630 5 = Epson LQ-850 6 = HP LaserJet/PCL 8 = KC-GL (Plotter) 9 = KPDL (an option on some models) Function The SEM command temporarily changes the printing system's emulation mode. The new mode remains in effect until another SEM or an RES (reset) command is issued. The SEM command also resets the margins and various other parameters. It should therefore be placed at the beginning of a program or file. The SEM command does not change the power-up emulation mode. When power is switched off, the printing system loses the mode set by the SEM command. Upon power up, it retains the default emulation, which is set by the P1 parameter of the FRPO command. If you usually work in 'emulation A' but occasionally use 'emulation B,' it is convenient to set 'emulation A' with the FRPO command and use the SEM command to change to 'emulation B' when necessary. In this case you must avoid using the RES command in 'emulation B,' because the RES command resets the printing system to 'emulation A.' File !R! CMNT To work temporarily in the LQ-850 emulation; SEM 5; EXIT; 287