Kyocera KM-6030 PRESCRIBE Commands Command Reference Manual Rev 4.8 - Page 232

PRESCRIBE Command Reference RESL - select RESoLution Format RESL resolution; Parameter resolution: 300 [dpi], 600 [dpi] or 1200 [dpi] Function The RESL command switches the resolution of the printing system between 300 dpi, 600 dpi, and 1200 dpi.When this command is received, the image data currently remaining is forcibly output on paper. This does not affect the current unit of measure, but the system's memory will be reconfigured, causing PCL resources (fonts, macros, patterns, and symbol sets) which have been downloaded into RAM to be purged. The printing system's resolution setting enabled by this command is reset to default (FRPO N8), if a command which results in reset (RES, FRPO and SEM) is received. Actual resolution may be decreased to 300 dpi even though printing resolution is set to 600 dpi or 1200 dpi when there is insufficient memory because a duplex unit is installed and duplex mode has been set or because the video memory size has been increased for page protection. Printing resolution cannot be switched from 300 dpi to higher resolutions for the following emulations: line printer, IBM ProPrinter, Diablo 630, EPSON LQ850. 222