Kyocera KM-6030 PRESCRIBE Commands Command Reference Manual Rev 4.8 - Page 260

PRESCRIBE Command Reference RWER W - [Read/Write External Resource] Write data to external media Format RWER W, medium, data-type[, 'partition-name']; Parameters medium: 0 = hard disk or RAM disk A = memory card data-type: 1 = Font data 2 = Printable data 16 = Macro data 112 = File data 128 = API data (downloadable program) partition-name: Name of partition to which data is written, in a maximum of 15 printable ASCII characters. If this parameter is omitted the printing system will automatically determine the partition name. Function The RWER W command writes data to any external media whether it is a memory card or the hard disk. Although all data types may be written up to the amount allowed by the storage size of the given media, note carefully that writing beyond this limit will result in data being interpreted as unneeded. Even if data is written to a device using the same file name, that data will be written without overwriting the original file. A partition list will be printed as a warning when this happens. A command error results and the command has no effect if parameters other than the above are used. This command causes a page break and prints a write information page when executed. The following example demonstrates how to send data from the computer to a memory card. Typically, partition names should be specified when writing to the card. If omitted, the partition names will be assigned automatically as follows: DataS001, DataS002 ... DataSnnn. Writing data to a memory card: To write the contents of file DATA123.DOC to partition DATA123 on the memory card: 250