Kyocera KM-6030 PRESCRIBE Commands Command Reference Manual Rev 4.8 - Page 397

XBCP 19 XBCP 19 - position symbols at the specified locations Format XBCP 19[, x1, y1, x2, y2, x3, y3, ...]; Parameter x1, y1, x2, y2, x3, y3, ... x and y coordinates that represent the positions of the divided barcodes measured from the current cursor position Function The multiple PDF417 symbol from one large data can be positioned at the specified locations using the XBCP 19 command. X1 , Y1 is the relative location of second PDF symbol to the first symbol, X2 , Y2 for third, and so on as measured from the current coordinate (like the MRP command described on the printing system's manual). The remaining pairs of positioning parameters are ignored if there are no more PDF symbol to print. The relative location parameters, Xn and Yn can not define the location beyond first page. The positioning command such as MZP and ENDB should be used to specify the macro PDF location if there are data beyond first page. PDF symbol will be positioned a half inch below the previous PDF symbol if there are no positioning parameter exist or insufficient number of positioning parameters exist. The combination with multiple number of ENDB command allows to print multiple number of macro PDF on multiple pages. Note RES, XBCP0, and XBAR command will delete the remaining macro PDF data if all data has not been printed. Therefore, the page eject should not be done by RES command. File 1 In Macro PDF mode, data such as large as 3000 bytes print 3 90-column-by-30-row PDF symbols at specified locations specified by XBCP 19. In the file below, the second line XBCP 17 activates Macro PDF mode and specifies QualitySt for file-id. The third line MZP command positions the first barcode at 1 inch each from the left and right paper edge limits. The fourth line XBCP 19 moves the cursor 1 inch from the left and 2 inches below the point where the first barcode started and prints the second barcode; then moves the cursor 1 inch from the left and 2 inches below the point where the second barcode started and prints the third barcode.: !R! RES; XBCP 17,"QualitySt"; MZP 1, 1; XBCP 19,1,2,1,2; XBAR; large data such as 3000 bytes;ENDB; EXIT; 387