Kyocera KM-6030 PRESCRIBE Commands Command Reference Manual Rev 4.8 - Page 323

SMLT SMLT - Set Miter LimiT Format SMLT limit-value; Parameter limit-value: Ratio of the length through a join to the width of line, expressed by the following formula (Default is 10. Minimum value is 1). miter length 1 limit-value = line width = sin (a/2) W = line width L = miter length W L Function The miter limit value set by the SMLT command is the maximum ratio of the miter length through a join to the width of the lines connected to each other. The default miter limit value is 10. In smaller miter-limit values, say 3, the miter join automatically switches to the beveled join. This switching prevents the problem of a spike extending beyond the intersection of the path because a small angle is used for the miter-join. Miter limit = 10 Miter limit = 3 313