Kyocera KM-6030 PRESCRIBE Commands Command Reference Manual Rev 4.8 - Page 42

PRESCRIBE Command Reference ASTK - Assign STacKer trays Format ASTK tray1, tray2, tray3, ...; Parameters tray1, tray2, tray3, ...: Number representing the tray in the optional sorter which becomes the last (bottom) tray in each group, as counted from the top towards the bottom tray. Function The ASTK command assigns the sorter trays in groups so that the sorter can be shared among the multiple users. Each parameter represents the last tray in each group of trays. The maximum number of parameters must be equal to the number of the trays the sorter is equipped with. By the factory default, the trays are grouped as the following table: Group 1 2 3 4 5 Equiv. ASTK command SO-6 1, 2 3, 4 5, 6 7, 8 9 to 15 ASTK 2, 4, 6, 8; Sorter model SO-30 1, 2 3, 4 5, 6 7, 8 9 ASTK 2, 4, 6, 8; SO-60 1, 2 3, 4 5 - - ASTK 2, 4; The ASTK command is ignored if parameters include the value greater than the actual number of trays. If the number of parameters is less than the maximum number of sorter trays, the printing system automatically groups the remaining trays in one, making it the last group. For example, the command sequence ASTK 2, 4, 6; is equivalent to ASTK 2, 4, 6, (bottom tray number);. The tray group setting made by ASTK is stored indefinitely in the printing system's permanent memory while the power is off, or until it is changed by another ASTK command. It is ignored in the normal sorter mode (FRPO S0, 0;) but the printing system automatically sets up the previous tray group setting when the sorter is again switched to the multiple environment mode (FRPO S0, 1; or FRPO S0, 2;). 32