Kyocera KM-6030 PRESCRIBE Commands Command Reference Manual Rev 4.8 - Page 235

RGST RGST - offset ReGiSTration Format RGST horizontal-offset, vertical-offset; Parameters horizontal-offset: horizontal offset value from the absolute coordinate (0, 0) for the physical paper feed direction, in current unit. The coordinates may be positive or negative. vertical-offset: vertical offset value from the absolute coordinate (0, 0) for the physical paper feed direction, in current unit. The coordinates may be positive or negative. Function This command moves the coordinate origin by the offset (physical horizontal and vertical directions) as measured from the values specified. The intersection (shared area) of the current printable area and the printable area shifted by the new offset registration is defined as the valid printable area. No page break is caused when this command is received. The offset values set using this command are valid even when the printing system is in HP emulation mode. Since this command is PCL command-compatible (&l #U, & l #Z), the offset values are cleared to zero only by a software reset (E). In other words, the offset is only cleared by PRESCRIBE (RES and FRPO INIT commands) when the emulation is HP. An error will result and the command has no effect if a command format other than the above is used. An error will result and the value in question will be ignored if horizontaloffset or vertical-offset is specified as a value exceeding the physical dimensions of the current paper size. 225