Kyocera KM-6030 PRESCRIBE Commands Command Reference Manual Rev 4.8 - Page 184

PRESCRIBE Command Reference MZP - Move to Zero-relative Position Format MZP x-coordinate, y-coordinate; Parameters x-coordinate: distance from the left edge limit of paper y-coordinate: distance from the top edge limit of paper Function The MZP command moves the cursor to a position specified relative to the top and left edge limits of the paper, measured in the units designated by the UNIT command. The coordinates may be positive or negative. Negative coordinates, however, move the cursor off the page, which should be avoided. The MZP command is ignored in the path mode graphics. To move to a zero-relative position in a path construction, use the PMZP (in Path, Move to Zero-relative Position) command. File !R! RES; UNIT C; STM 2; SLM 2; SFNT 'Helvetica-Nr'; MZP 0, 0; BOX 40, 40; SPD .2; MZP 0, 4; TEXT '< = = = Edge limits'; MZP 0, 0; CIR .1; TEXT, L; TEXT ' MZP 0, 0;'; MZP 6, 0; CIR .1; TEXT, L; TEXT ' MZP 6, 0;'; MZP 0, 2; CIR .1; TEXT, L; TEXT ' MZP 0, 2;'; MZP 6, 2; CIR .1; TEXT, L; TEXT ' MZP 6, 2;'; PAGE; EXIT; 174