Kyocera KM-6030 PRESCRIBE Commands Command Reference Manual Rev 4.8 - Page 230

PRESCRIBE Command Reference RES - RESet Format RES; Parameter None Function The RES command causes a page break and resets parameters as indicated below. Some reset values can also be changed by the FRPO command. For these, the factory reset value is given, followed by the FRPO parameters that can be used to change this value in parenthesis. In HP-7475A emulation, the RES command resets the printer environment in the same manner as the KC-GL DF instruction. Refer to section HP 7550A Emulation [KC-GL] (Mode 8) of the Technical Reference manual. The RES command does not: • delete permanent macros or permanent fonts from memory • delete positions or fonts stored by the SCP and SCF commands • reset font attributes set by the SFA command • change any values in permanent memory (Refer to the FRPO INIT command page.) Parameter Value after reset (Related FRPO parameter) LaserJet (PCL) IBM/Epson Command recogni- R (P9) ← ← tion character Emulation mode 6 (P1)a ← ← Unit of measure- Inches ← ← ment Number of copies 1a ← ← per page Cassette Cassette 1 (main cassette) (R4)a ← Paper tray Face-down (R0)a ← ← Paper size Cassette size (R2)a ← ← Top margin 1/2 inch (150 dots) 0 (A1/2) ← Left margin Left logical 0 (A3/4) ← Right margin Right logical Max. size (A5/6) ← Bottom margin 1/2 inch (150 dots) Max. size (A7/8) ← Diablo Page orientation Line spacing Character spacing Portrait (Orienta- Portrait (Orienta- Portrait (C1)† tion of font C5/2/3) tion of font C5/2/3) 6 lpi (U0/1) ← ← 10 cpi (Spacing of 10 cpi (U2/3) ← font C5/2/3) Related PRESCRIBE Com- mands SCRC SEM UNIT COPY PSRC STAK SPSZ STM SLM SRM, SPW SBM, SPL, SLPP SPO SLS, SLPI SCS, SCPI 220