Kyocera KM-6030 PRESCRIBE Commands Command Reference Manual Rev 4.8 - Page 47

BARC Type Max Characters to be used 40 1 The following FIM pattern type A. Country Reply Mail with POSTNET B. Business Reply, Penalty and Franked Mail without POSTNET C. Business Reply, Penalty and Franked Mail with POSTNET D. OCR Readable Mail without POSTNET 41 125 0123456789 42 80 All (ASCII characters 32 - 126) 43 1 - 20 0123456789ABCDEFGHIJKLMNOPQRSTUVWXYZ 44 3 - 32 $+-./0123456789:abcdetn* and spaces Default 0 0 - Length of the bars For the UPC and EAN (JAN) barcode type, the length of the short and tall bars can be adjusted. When adjusting the length of the tall or short bars, specify that of both tall and short bars. If the length of only the tall or short bars is adjusted, the bars' length does not change. It is recommended to use the dot for the unit of measurement in order to avoid the translation error by the barcode reader. In the example below, the length of the short bar is specified as 1.5cm and the tall bar as 1.7cm. !R! UNIT D; BARC 8, Y, '123456', 180, 200; PAGE; EXIT; Width and space of the bar It is possible to adjust the widths of the bars and space between the bars. When adjusting these widths, specify all of the eight width and space parameters. Specify the bar 1 to bar 4 in the ascending order. The values can be specified between 1 and 200 dots. 1dot ≤ bar1 < bar2 < bar3 < bar4 ≤ 200dots 1dot ≤ space1 < space2 < space3 < space4 ≤ 200dots It is recommended to use the dot for the unit of width in order to avoid the translation error by the barcode reader. The example below specifies the width of the first bar and space as 5 dots and that of the remaining bars as 10 dots. !R! UNIT D; BARC 19, Y, '0123ABC', 60, 60, 5, 10, 10, 10, 10, 5, 10, 10; PAGE; EXIT; 37