Brother International PR-620 Users Manual - English - Page 157

BASIC SETTINGS AND HELP FEATURE Using the Settings Key Touch (settings key) to change many of the basic embroidery machine settings. Understanding the settings screen There are five pages in the settings screen. Touch and in the lower-right corner of the screen until the desired page is displayed. The key appears on all pages. ■ Page 1 ■ Page 2 1 Touch to quit specifying settings. The settings are confirmed and the screen that was displayed before the settings key was touched appears again. 2 The guides (embroidery frame size, centerpoint marker, grid and cursor) for the pattern display area can be specified. 3 The TOTAL COUNT counter shows the total number of stitches, and the TRIP COUNT counter show the number of stitches that have been sewn since the machine's last maintenance. 4 The TOTAL TIME counter shows the total amount of time that the machine has been used, and the TRIP TIME counter shows the amount of time that the machine has been used since its last maintenance. Use counters 3 and 4 as a standard for performing periodic maintenance and for receiving maintenance for the machine. 5 VERSION Shows the version of the software installed on this embroidery machine Note ● Check with your local authorized Brother dealer or at www.brother.com for details on available updates. 6 CHANGING THE THREAD COLOR DISPLAY The color information in the thread color sequence display and the needle bar thread information can be switched to the color name, the thread color number or the sewing time, refer to page 145. 7 DISPLAY EXPANDED THREAD COLOR The thread colors displayed in the thread color sequence display and in the needle bar thread information can be displayed as a color from the machine's built-in color thread table, as a thread color from another manufacturer, or as a color that is created with PE-Design ver. 5.0 as an original color chart. If "ON" is selected, choose from the following three threads, refer to page 146. Original Thread Custom Thread 1 Custom Thread 2 8 THREAD TRIMMING/"DST" SETTING Specifies whether or not jumpstitches are cut. In addition, when using Tajima embroidery data (.dst), you can specify whether or not the thread is cut according to the specified number of jump codes. (Refer to page 149.) 9 SHORT STITCH DELETE Specifies the pitch length of short stitches that are to be deleted, refer to page 150. 0 THREAD TAIL Specifies the length of upper thread that remains threaded through the needle after the thread is trimmed (length of thread passed through the eye of the needle), refer to page 150. 140