Brother International PR-620 Users Manual - English - Page 167

BASIC SETTINGS AND HELP FEATURE ■ When using Tajima embroidery data (.dst) If "ON" is selected, touch and to 2 select the number of feed codes. The desired setting is displayed. Touch and to select the pitch size. 1 The desired size is displayed. • A value between 1 and 8 can be specified. For example, if 3 is specified, sequential 3 jump codes will be converted to the trim code. But sequential 2 jump code will not be converted to the trim code, it will be sewed as the feed (jump) stitch. Note ● You need to set the jump number same as the number that was used when the particular Tajima data was created. If the jump number is not matched, either unexpected trim or no trimming at trim expected point will happen. Deleting short stitches If embroidery data other than our original patterns is used, the pitch may be too small, which may result in the thread or the needle breaking. In order to prevent this, the machine can be set to delete stitches with a fine pitch. Stitches with a pitch less than that specified here can be deleted. When the embroidery machine is purchased, "0" was selected (delete stitches with a pitch of 0). The setting to delete short stitches can be specified from the second page of the settings screen. • A value between 0 and 1 millimeters if the units of measurements is set to "mm" (or a value between 0 and 0.04 inch if the units of measurements is set to "inch") can be specified. Specifying the remaining length of thread This setting specifies whether the length of upper thread that remains threaded through the needle after the thread is trimmed (length of thread passed through the eye of the needle) has a standard tail or long tail. When the embroidery machine is purchased, "standard tail" is selected. The setting for the remaining length of thread can be specified from the second page of the settings screen. Touch and to select the setting. 1 The desired length is displayed. • If the machine misses stitches with a standard length of thread after it is trimmed, select "Long tail". • When using metallic thread, select "Long tail". 150