Brother International PR-620 Users Manual - English - Page 25

GETTING READY . Setting up the machine When setting up the machine, adjust the legs so that the machine is steady. Make sure that all packing tape affixed to the 1 machine is peeled off and that all packing material is removed. Set up the machine while making sure that 2 there is sufficient space around it. More than 50 mm (2 inches) 589 mm (23-3/16 inches) More than 350 mm (13-3/4 inches) More than 512 mm More than 250 mm (20-5/32 inches) 250 mm (9-7/8 inches) (9-7/8 inches) Use the included wrench to turn the 4 adjustable foot nut on the foot. Turning the nut in direction 1 lengthens the leg; turning the nut in direction 2 shortens the leg. 2 1 1 1 Adjustable foot nut • Adjust all four legs so that they securely contact the desk or table. After adjusting the legs to the desired length, 5 use the included wrench to tighten the nuts. Adjust the legs so that the machine is steady. 3 Use the included wrench to loosen the lock 1 nut on the leg that you wish to adjust. 1 2 1 Lock nut 2 Adjustable foot nut X The foot can be turned. 1 Lock nut Press down on each corner of the embroidery 6 machine to check that it is stable. If it is still unstable, perform steps 3 through 5 again to adjust the legs. 8