Brother International PR-620 Users Manual - English - Page 27
Preparing the thread guide, assembly
View all Brother International PR-620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
GETTING READY Preparing the thread guide assembly Raise the thread guide assembly. Locate the included Phillips screwdriver. Using the Phillips screwdriver, loosen the 1 screws on the left side of the thread guide assembly support so that the thread guide assembly can be raised. Remove screw 1, and then turn screw 2 three or four times to loosen it. Using the Phillips screwdriver, loosen the 3 screws on the left and right sides of the thread guide assembly and lift up the thread guide so that it is level. 1 1 Loosen Screws Tighten the screws on the left and right sides 4 of the thread guide assembly. 1 Remove the screw. 2 Turn the screw three or four times to loosen it. Raise thread guide into position and tighten 2 screw2 on the left. Insert screw1 into right side of the thread guide assembly support and tighten. 1 Insert screw and tighten. 2 Tighten screw. 10 Note ● If the screws are not loosened enough, it may not be easy to move the thread guide assembly support and the thread guide. Do not apply extreme force when moving the thread guide assembly support and the thread guide. Be sure that the screws are loosened well enough before moving these parts. ● Be sure to tighten each screw well enough that the thread guide assembly support and the thread guide are secured.